Dave describes how to get the software, install it, and establish communication with your DCC system. DecoderPro is part of the Java Model Railroading Interface - a free open source model railroading software project. The GUI is slightly different, but the basic functionality is the same. Introduction to Decoder Pro - segment 1 (14:56) - Dave Duchamp, one of the JMRI developers, introduces the DecoderPro program. DecoderPro for Windows 1.6 cannot be uninstalled due. Since the signal after BPF is output to the audio output, it can also be used as an AF-CW filter. Files and folders of DecoderPro for Windows 1.6 can be found in the hard disk after the uninstallation. * The Pro version also supports waterfall display.ġ.Language select English and Japanese(KANA)ġ0.CW Speed Control Low, Mid1, Mid2 or Highġ5.Support the Garbage Data reduction function * There will be a time lag of about 1 to 2 seconds for AFD tracking. You can also hold the AFD / AGC parameters by pressing the Lock button. The decoder using FFT automatically follows the strongest signal in the band by AFD (Auto Frequency Detector) and AGC (Auto Gain Control). AFD (Auto Frequency Detector) function has been added to the decoder using BPF, and BPF can be set automatically by pressing the AFD button. Following procedure for removing old java and installing, then running DecoderPro produced the following errors:-DecoderPro3.exe - Entry Point Not Found The procedure entry point K32GetModuleFileNameExA could not be located in the dynamic link library KERNE元2.dll-Java Virtual Machine Launcher Error:loading: C:\Program Files\Zulu\zulu-11. In addition to the decoder using BPF, a new decoder using FFT has been added so that it can be switched according to the usage. Make fine adjustments to each parameter according to the reception status. Usually about 5 to 10 characters are required for speed synchronization of Morse Code.Īdjust the input signal so that the peak value changes from level 6 to level 7. .uk Sprog DCC SprogII SPROG II - includes USB cable and JMRI/DecoderPro software and drivers on CD-ROM Requires a regulated DC power supply 12V/1. Signals with good S/N can be decoded correctly, but signals with bad S/N cannot be decoded correctly.Īlso, the performance will be degraded for extremely slow or fast signals. It is a Morse practice App that you can use to check if you are keying the correct code. I recommend that you try the basic functions and usage with the free version before purchasing. This is an App that decodes Morse code input from the microphone.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |